Topography

i will be oredering this tomorrow probably so i was wondering if i got it right.

I’m getting two —
PIONEER TS-W3001D4 (TSW3001D4)
12 PREMIER CHAMPION Series PRO 3000W SUBWOOFER

Features:

o 12 Champion Series Pro
o Woofer Cone Material : Interlaced Carbon Fiber/Glass Fiber Reinforced
o Surround : Wide-Roll, 3-Layer Fiber Woven Aramid Radial with Honeycomb Cloth
o Voice Coil : Dual 4-Layer, Long Voice Coil
o Voice Coil Wire : Copper
o Voice Coil Bobbin : Phenol Resin Coated Glass Cloth
o Projected Pole Yoke with Vented Pole
o Magnet : Double Stacked 110oz
o Aluminum Die-Cast Rigid Chassis
o Gasket 1-Piece Rubber
o Integrated Single-Sided Silver Compression Terminals
o Max Power : 3000 W
o Nominal Power Handling : 1000 W
o Frequency Response : 18 - 700 Hz
o Sensitivity : 89 dB
o 2 or 8 ohm Capability
o Recommended Enclosure Size : 0.50 ~ 1.0 Cubic Ft
o Mounting Depth : 7.5

hooked up to this amp at a 1ohm load –
HIFONICS BXi2008D MONO Class-D 2000W BRUTUS Series 25TH Anniversary AMPLIFIER

Features:

o 1-Channel Mono-Block Operation
o 650 Watts RMS x 1 @ 4-Ohms
o 1300 Watts RMS x 1 @ 2-Ohms
o 2000 Watts RMS x 1 @ 1-Ohms
o SUPER D-Class Amplifier Topography
o Ultra-Fi MOSFET Outputs
o Illuminated HIFONICS Logo
o PWM MOSFET EXVP (Exponential Vari-Power Supply)
o SPC Twin Turbo-Torroids with Simpatico Coil Design
o Fully Adjustable Accu Cross Crossover
+ 24dB Subsonic Filter (Adjust 15Hz~35Hz)
o Phase Shift Adjustments (0 to 180 Degrees)
o 24dB Low-Pass Crossover (Adjust 35Hz~250Hz)
o Bass Boost : Variable Equalization (+10dB @ 45Hz)
o Remote Bass Control Included
o Balanced Line Inputs with optional Hifonics MM-BLD-1
o Gold RCA Line Outputs
+ Permits Amplifier Daisy Chaining
+ 0.2V to 9V Signal Level
o 4-Gauge Power Connectors

* SPECIFICATIONS
o Amplifier Class : Class-D
o Number of Channels : 1-Channel
o Maximum Power : 2000 Watts
o RMS Power Output @ 4 Ohms : 650 Watts x 1-Channel
o RMS Power Output @ 2 Ohms : 1300 Watts x 1-Channel
o Bridged Power : N/A
o THD : 0.08%
o Signal-to-Noise Ratio (dB) : 95dB
o Frequency Response (Hz) : N/A
o Built-in Crossover : Yes
o High-Pass Crossover Frequency : N/A
o Low-Pass Crossover Frequency : 35Hz~250Hz
o Bass Boost : 0dB~10dB
o Bass Remote : Yes
o Fan Cooled : N/A
o Fuse Rating : 200A Dimensions (Width x Height x Length) Inches : 9.45 x 2.52 x 14.97
o Approximate Weight : 15.6 LBS

the sub woofers will go in this box –
HBX 12VEGA 12 Dual Ported MDF Sub woofer Box

I was told i needed a capacitor so i’m going to get this one-

SPL CP5.0 (CP50) 5-Farad 5000W Digital Power CAPACITOR

Features:

o Digital Hybrid Power Capacitor
o 5 Farad
o 24 Volts DC
o Blue LED Lights
o Brushed Aluminum with Black Mesh Jacket
o Chrome Mounting Brackets

This amp install kit –

EARTHQUAKE AK-5000 (AK5000 4-Gauge 5000W Complete Amplifier Installation KIT

* Includes:
o Red Power Wire : 17 ft : 4-Gauge
o Black Ground Wire : 3 ft : 4-Gauge
o Speaker Wire : 20 ft : 16-Gauge
o Blue Remote Turn On Wire : 16 ft : 16-Gauge
o Silver Twisted-Pair RCA Interconnect : 6 ft : Straight
o Black Split Loom : 6 ft : OD 8mm
o Gold Plated ANL Fuse Holder : ANL Fuse : 150 A
o 4 x 4 Gauge Gold O Ring Terminal : 2 Red / 2 Black
o 2 x 4 Gauge Gold U Ring Terminal : 1 Red / 1 Black
o 4 x 14-16 Gold gauge U Terminal for speaker terminals on amp : 2 red / 2 black
o 1 x 16-22 Gauge butt connector for remote turn-on wire : 1 red
o 1 x self tapping screw : 1 tinned
o 10 x black cable ties : 120mm long
o 1 x grommets in black

and this speaker wire:

AVS SPW12-50 12GA 50FT SPEAKER WIRE

Adrien